Kohler KDI 3404TCR Owner's Manual page 21

•
To start the engine follow the specific instructions provided in the engine and/or machine operating manual.
Do not use auxiliary starting devices not originally installed on the machine (e.g. Startpilot).
• Before starting, remove any tools that were used to service the engine and/or machine. Make sure that all
guards have been refitted.
• Do not mix fuel with elements such as oil or kerosene. Failure to comply with this prohibition will cause the
non-operation of the catalyst and non-observance of the emissions declared by KOHLER .
•
Pay attention to the temperature of the oil filter when the filter itself is replaced.
• Only check, top up and change the coolant fluid when the engine is off and reached the ambient
temperature. Coolant fluid is polluting, it must therefore be disposed of in the correct way.
• Do not use air and water jets at high pressures on cables, connectors and injectors.
Important
• Only use the eyebolts A installed by KOHLER to move the engine (Fig. 3.1) .
•
The angle between each lifting chain and the eyebolts shall not exceed 15° inwards.
• The correct tightening of the lifting screws is 80Nm.
•
Do not interpose spacers or washers between the eyebolts and engine head.
• Provided that the above requirements are met, if the lifting eyebolts are subject to permanent deformation
(inwards), all subsequent lifting operations must be performed in order to prevent them from bending in the
opposite direction.
•
Engines equipped with an ATS device require regeneration to be inhibited if the engine is used in
environments at risk of fire (e.g. forest areas, areas with flammable materials, areas with flammable gases or
liquids and any type of combustible material - if the function is available).
Fig 3.1
SAFETY INFORMATION
3
21
EN