6
6.4 Filter cartridge and fuel pre-filter replacement
Important
•
Before proceeding with operation,
read
Par. 3.2.2
Warning
•
In case of low use replace il 12 months.
•
For disposal of oil filter cartridge and
fuel filter refer to
and SCRAPPING
1. Disconnect the cable A of the water
presence sensor C .
2. Remove the water presence sensor C
from its cartridge B .
3. Loosen the cartridge B using the
appropriate wrench F (Fig. 6.10) .
4. Lubricate the gasket D of the new
cartridge B.
Important
• Do not fill the new cartridge B with fuel.
5. Tighten the new cartridge B (Fig. 6.10)
on the diesel fuel filter support E using
the special wrench F (tightening torque
of 17 Nm ).
6. Tighten the water presence sensor C on
the new cartridge B (tightening torque of
5 Nm ).
7. Reconnect the cable A of the water
presence sensor C .
8. Push repeatedly the button G in order to
fill the circuit.
NOTE : Click on the right to play the procedure.
EN
50
INFORMATION ABOUT REPLACEMENTS
Par. 6.6 DISPOSAL
Fig 6.9
Fig 6.10
https://www.youtube.com/embed/MXs9IUimUi4?rel=0