Table of Contents
Advertisement
10.Stopping:
a. Disengage cradle tilt hydraulic circuit.
b. Allow rotor to run until no more material comes out of discharge
opening.
c. Slowly decrease engine RPM to idle.
d. Disengage PTO drive and wait for rotor to stop turning.
IMPORTANT
Disengage PTO clutch and wait until rotor stops turning before pushing
the PTO clutch lever into its off detent if the PTO drive system on your
tractor is designed with a brake that will top the PTO shaft in less than one
revolution. Stopping this
11.Discharge Deflector:
The
Bale Processor
designed with a discharge
deflector that can be set
in several positions to allow
placing
the
material
in
feeding
or
fully
bedding. Place the anchor
pin in the desired hole for
your application.
is
shredded
rows
for
up
for
- 4.12 -
L
R
NOV 2016
VK
Advertisement
Table of Contents
