Table of Contents
Advertisement
6. Remove the strings, twine or wrapping from the bale.
7. Raise the bale tines and tip the bale into the machine.
8. At this time another bale can be picked up on the forks and brought
to the feeding area if desired.
9. Starting Machine:
a. Set the discharge deflector at the desired position.
b. Start the tractor and run at idle.
c. Drive to the desired unloading location.
d. With the tractor at idle, slowly engage PTO.
IMPORTANT
The Bale Processor is equipped with an 80º constant velocity drive line.
When operating the Bale Processor, keep the PTO drive line as
straight as possible to have the universal joint angles as small as
possible. Avoid sharp turns with the PTO engaged. If a sharp turn is
unavoidable, disengage PTO. Operating at more than 80º will damage
the CV joint and will void warranty.
e. Increase engine RPM to rated PTO speed.
f. Engage cradle tilt hydraulic circuit.
- 4.11 -
L
R
NOV 2016
VK
Advertisement
Table of Contents
