Removing The Chassis Cover - Supermicro SUPERSERVER 6028U-T Series User Manual

6-3

Removing the Chassis Cover

1. If rack mounted, first, grasp the two handles on either side and pull the system
straight out until it locks (you will hear a "click").
2. Remove the two screws on each side of the cover, which secure the cover to
the chassis.
3. Press the release tabs to remove the cover from the locked position. Press both
tabs at the same time.
4. Once the top cover is released from the locked position, slide the cover toward
the rear of the chassis.
5. Lift the cover off the chassis.
6. To remove the system from the rack completely, press the locking tabs in the
chassis rails (push the right-side tab down and the left-side tab up) to continue
to pull the system out past the locked position. See Figure 6-2.
Figure 6-2. Accessing the Inside of the System
1
2
Remove
Screw
1
3
6-3
Chapter 6: Advanced Chassis Setup
1
5
1
4
1
3
1
2
Remove
Screw