Supermicro SUPERSERVER 6028U-T Series User Manual page 106

SuperServer 6028U-T Series User's Manual
SATA/sSATA RAID Boot Select
Select the boot capability for SATA or SATA RAID controllers. This is shared and
presented in the SATA Configuration page and the sSATA Configuration page.
The options are SATA Controller, sSATA Controller and Both. (Note: The Both
option cannot support Windows Server 2012 r2 installation.)
sSATA Port 0~ Port 3
This item displays the information detected on the installed SATA drive on the
particular SATA port, including the model number of the drive, capacity, and the
Software Preserve Support.
sSATA Port 0 ~ Port 3 Spin Up Device
Only devices for which this is Enabled will spin up at boot. The options are
Enabled and Disabled. If no devices are Enabled, all will spin up at boot.
Port 0 ~ Port 3 sSATA Device Type
For each port, you can identify whether it is connected to a hard drive or a
solid state drive.
Server ME Configuration
This screen displays the Management Engine configuration information, including
Operational Firmware Version, Recovery Firmware Version, ME Firmware Features,
ME Firmware Status #1, ME Firmware Status #2, Current State, Error Code.
No settings are configurable.
PCIe/PCI/PnP Configuration
PCI PERR/SERR Support
Choose whether to allow a PCI/PCI-E device to generate a PCI/PCI-E Parity-Error
(PERR) number or a System-Error (SERR) number for a PCI Bus Signal Error
Event. The options are Enabled and Disabled.
Above 4G Decoding (Available if the system supports 64-bit PCI decoding)
Choose to allow decoding a PCI device that supports 64-bit in the space above 4G
Address. The options are Enabled and Disabled.
SR-IOV Support
If the system has PCI-E devices that supports Single Root IO Virtualization (SR-
IOV), choose to Enable or Disable it.
7-18