Supermicro SUPERSERVER 6028U-T Series User Manual page 104

SuperServer 6028U-T Series User's Manual
If SATA is configured as RAID, the following items are displayed:
The SATA ports are listed.
Support Aggressive Link Power Management
When this item is set to Enabled, the SATA AHCI controller manages the power
usage of the SATA link. The controller will put the link in a low power mode during
extended periods of I/O inactivity, and will return the link to an active state when
I/O activity resumes. The options are Enabled and Disabled.
SATA RAID Option ROM/UEFI Driver
Select which SATA RAID firmware type to load. The options are Disabled, EFI,
and Legacy.
SATA/sSATA RAID Boot Select
Select the boot capability for SATA or SATA RAID controllers. This is shared and
presented in the SATA Configuration page and the sSATA Configuration page.
The options are SATA Controller, sSATA Controller and Both. (Note: The Both
option cannot support Windows Server 2012 r2 installation.)
SATA Port 0~ Port 5
This item displays the information detected on the installed SATA drive on the
particular SATA port, including the model number of the drive, capacity, and the
Software Preserve Support.
Port 0 ~ Port 5 Spin Up Device
Only devices for which this is Enabled will spin up at boot. The options are
Enabled and Disabled. If no devices are Enabled, all will spin up at boot.
Port 0 ~ Port 5 SATA Device Type
For each port, you can identify whether it is connected to a hard drive or a
solid state drive.
sSATA Configuration

When this submenu is selected, the BIOS automatically detects the presence
of the sSATA devices that are supported by the Intel PCH chip and displays the
following items:
SATA Controller
This item enables or disables the onboard SATA controller supported by the Intel
PCH chip. The options are Enabled and Disabled.
7-16