Supermicro SUPERSERVER 6028U-T Series User Manual page 108

SuperServer 6028U-T Series User's Manual
Select PXE (Preboot Execution Environment) to use a PXE Option ROM to boot
the computer using a PXE network device. The options for Onboard LAN 1 are
PXE , iSCSI, FCoE, and Disabled.
Onboard LAN(2-4) Option ROM
(Available only if you choose PXE or Disable for LAN1) Choose whether to allow
PXE firmware for LAN2, LAN3, and LAN4. Options are PXE and Disable.
Onboard Video Option ROM
This feature controls how the system executes UEFI (Unified Extensible Firmware
Interface), and legacy Option ROM. Select Legacy only to boot the system using a
legacy video device. The options are Disabled, Legacy, and EFI.
VGA Priority
This feature allows the user to select the graphics adapter to be used as the primary
boot device. The options are Onboard, and Offboard.
Network Stack
When this feature is set to Enabled, both PXE (Preboot Execution Environment)
and UEFI (Unified Extensible Firmware Interface) will be enabled for network stack
support. The options are Enabled and Disabled.
Super IO Configuration
Super IO Chip
This item displays the Super IO chip used in the motherboard.
Serial Port 1 (or 2) Configuration
Serial Port
Select Enabled to enable a serial port specified by the user. The options are
Enabled and Disabled.
Change Port Settings
This option specifies the base I/O port address and the Interrupt Request
address of Serial Port 1 (COM). Select Disabled to prevent the serial port from
accessing any system resources. When this option is set to Disabled, the serial
port becomes unavailable. The options are Auto, IO=3F8h; IRQ=4; IO=3F8h;
IRQ=3, 4, 5, 6, 7, 10, 11, 12; IO=2F8h; IRQ=3, 4, 5, 6, 7, 10, 11, 12; IO=3E8h;
IRQ=3, 4, 5, 6, 7, 10, 11, 12; IO=2E8h; IRQ=IRQ=3, 4, 5, 6, 7, 10, 11, 12.
7-20