Supermicro SUPERSERVER 6028U-T Series User Manual page 116

SuperServer 6028U-T Series User's Manual
Erasing Settings
Erase SEL
Select 'Yes, On next reset' to erase all system event logs upon next system reboot.
Select 'Yes, On every reset' to erase all system event logs upon each system reboot.
Select No to keep all system event logs after each system reboot. The options are
No, "Yes, On next reset," and "Yes, On every reset."
When SEL is Full
This feature allows the user to decide what the BIOS should do when the system
event log is full. Select "Erase Immediately" to erase all events in the log when
the system event log is full. The options are Do Nothing and Erase Immediately.
BMC Network Configuration

IPMI LAN Selection: This item displays the available IPMI LAN modes.
IPMI Network Link Status: This item displays the IPMI Network Link status.
Update IPMI LAN Configuration
This item allows the user to set whether the BIOS should configure the IPMI settings
at next system boot. The options are No and Yes. If the option is set to Yes, the
user is allowed to configure the following IPMI settings at next system boot:
Configuration Address Source
This item allows the user to select the source of the IP address for IPMI. The options
are Static and DHCP.
If the Address Source is set to DHCP, the following information is displayed and not
configurable. If the Address Source is set to Static, the Station IP Address, Subnet
Mask, and IP Gateway IP Address can be configured. You must gather these
parameters from your network administrator and enter them manually.
Station IP Address: In dotted quad form, for example 192.168.10.253
Subnet Mask: In dotted quad form, for example 255.255.0.0
Station MAC Address: Six two digit hexidecimal pairs, for example
1a.34.5e.b8.65.37.
Gateway IP Address: In dotted quad form, for example 192.168.0.1
7-28