Verifying Post-Installation Connectivity; Electrical And Environmental Specifications; Regulatory Model Number; Safety And Regulatory Compliance - Aruba 560EX Series Installation Manual

Verifying Post-Installation Connectivity

The integrated LEDs on the access point can be used to verify that the access point is receiving power and
initializing successfully (see
on verifying post-installation network connectivity.

Electrical and Environmental Specifications

Electrical
Ethernet

E0: 100/1000Base-T auto-sensing Ethernet RJ-45 Interfaces

Power over Ethernet (IEEE 802.3af and 802.3at compliant)

Environmental
Operating

Temperature: -40ºC to 55ºC (-40ºF to 131ºF)

Humidity: 5% to 93% (RH) non-condensing

Storage

Temperature: -40ºC to 70ºC (-40ºF to 158ºF)

Humidity: 5% to 93% (RH) non-condensing

For additional specifications on this product, please refer to the data sheet at www.arubanetworks.com.

Regulatory Model Number

For the purpose of regulatory compliance certifications and identification, this product has been assigned a
unique regulatory model number (RMN). The regulatory model number can be found on the product nameplate
label, along with all required approval markings and information. When requesting compliance information for
this product, always refer to this regulatory model number. The regulatory model number RMN is not the
marketing name or model number of the product.
The following regulatory model numbers apply to the 560EX Series:
AP-565EX RMN: APEX0565

AP-567EX RMN: APEX0567


Safety and Regulatory Compliance

RF Radiation Exposure Statement: This equipment complies with RF radiation exposure limits. This
!
equipment should be installed and operated with a minimum distance of 7.87 inches (20 cm) between the
radiator and your body for 2.4 GHz and 5 GHz operations. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Déclaration de la concernant l'exposition aux rayonnements à fréquence radioélectrique (FR): Cet
appareil est conforme aux limites d'exposition aux rayonnements FR établies par la FCC. Il doit être installé et
!
utilisé à une distance minimale de 20 cm (7.87 pouces) entre le radiateur et votre corps, qu'il opère sur la
bande 2,4 GHz ou 5 GHz. Cet émetteur ne doit pas être installé ou utilisé à proximité immédiate d'une autre
antenne ni d'un autre transmetteur.
The device could automatically discontinue transmission in case of absence of information to transmit, or
!
operational failure. Note that this is not intended to prohibit transmission of control or signaling information
or the use of repetitive codes where required by the technology.
Aruba 560EX Series Hazardous Location Access Points
Table 1 and Table 2). Refer to the AP Software Quick Start Guide for further details
| Installation Guide
11