Verifying Post-Installation Connectivity; Environmental And Electrical Specifications - Aruba 220 Series Installation Manual

Power Connection
The AP-220 Series has a single 12V DC power jack socket to support powering through an AC-to-DC power
adapter.
If both PoE and DC power are available, the AP draws power from the PoE source.
Software
Aruba 220 Series requires ArubaOS 6.3.0.0 or later.
For instructions on choosing operating modes and initial software configuration, refer to the Access Point
Software Quick Start Guide.
Aruba access points are classified as radio transmission devices, and are subject to government regulations of
!
the host country. The network administrator(s) is/are responsible for ensuring that configuration and operation
of this equipment is in compliance with their country's regulations. For a complete list of approved channels in
your country, refer to the Aruba Downloadable Regulatory Table at

Verifying Post-Installation Connectivity

The integrated LED on the access point can be used to verify that the access point access point is receiving power
and initializing successfully (see
verifying post-installation network connectivity.

Environmental and Electrical Specifications

For additional specifications on this product, please refer to the product data sheet at
support.arubanetworks.com
Environmental
Operating:

Temperature: 0°C to +50°C (+32°F to +122°F)

Humidity: 5% to 93% non-condensing

Storage and transport:

Temperature: -40°C to +70°C (-40°F to +158°F)

Humidity: 5% to 93% non-condensing

Electrical
Ethernet:

2 x 10/100/1000Base-T auto-sensing Ethernet RJ-45 Interfaces

MDI/MDX

IEEE 802.3 (10Base-T), IEEE 802.3u (100Base-T). IEEE 802.3ab (1000Base-T)

Power over Ethernet (IEEE 802.3at compliant), 48V DC (nominal) and 56V DC (maximum)/350mA (see

Figure 5
Power:

12 VDC power interface, supports powering through an AC-to-DC power adapter

POE support on Ethernet ports: 802.3at-compliant POE sourcing devices

Connect Only to IEC 60950-1 or IEC 60601-1 3rd edition products and power sources.

If a power adapter other than the one provided by Aruba Networks is used in the US or Canada, it must be cULus
(NRTL) Listed, with an output rated 12 VDC, minimum 1.25A, marked "LPS" or "Class 2," and suitable for plugging
into a standard power receptacle in the US and Canada.
Aruba 220 Series Access Points
Table 1). Refer to the Access Point Software Quick Start Guide for further details on
for pin configuration)
| Installation Guide
support.arubanetworks.com
.
9