Electrical And Environmental Specifications; Regulatory Information - Aruba IAP-367 Installation Manual

Aruba 360 Series Outdoor Access Point
Regulatory Compliance and Safety Information Guide
Introduction
This document contains domestic and international regulatory compliance and safety information for the access
point. To ensure that this device complies with the regulatory standards for your region, please refer to the
sections below.

Electrical and Environmental Specifications



Regulatory Information


Proper Disposal of Aruba Equipment

Electrical and Environmental Specifications
For additional specifications on this product, please refer to the product data sheet at
All Aruba access points should be professionally installed by an Aruba Certified Mobility Professional (ACMP).
!
The installer is responsible for ensuring that grounding is available and meets applicable national and electrical
codes.
Tous les points d'accès Aruba doivent impérativement être installés par un professionnel agréé. Ce dernier
!
doit s'assurer que l'appareil est mis à la terre et que le circuit de mise à la terre est conforme aux codes
électriques nationaux en vigueur.
Electrical
Ethernet:

One 10/100/1000 Base-T auto-sensing Ethernet interface (RJ-45)

Power:

Maximum (worst-case) power consumption: 12.95W (802.3af PoE)

Power over Ethernet (PoE): 802.3af complaint source

Connect only to IEC 60950-1 or IEC 60601-1 3rd edition products and power sources.

Environmental
Operating:

Temperature: -40°C to +50°C (-40°F to +122°F)

Humidity: 5% to 93% non-condensing

Storage and transport

Temperature: -40°C to +70°C (-40°F to +158°F)

Regulatory Information
The following regulatory model names apply to the 360 Series access points:
AP-365/IAP-365: APEX0365

AP-367/IAP-367: APEX0367

Aruba provides a multi-language document that contains country-specific restrictions and additional safety and
regulatory information for all Aruba access points. This document can be viewed or downloaded from the
following location: www.arubanetworks.com/safety_addendum.
FCC
This device is electronically labeled.
To view the FCC ID for controller-managed access points:
1. Log into the controller WebUI
2. Navigate to Maintenance > Controller > About
0511954-01 | October 2016
www.arubanetworks.com.
1