Table of Contents
Advertisement
Figure 5
1. Remove the dust cap from the Ethernet port.
2. It is not necessary to dismantle the cable gland any further than illustrated in
3. Fit the cable gland into the Ethernet port with the shroud and fully tighten the entry item.
4. Determine the conductor length required to suit the installation and prepare the cable accordingly, removing
part of the outer sheath where required to reveal the insulated conductors.
5. Slacken the seal nut to relax the seal.
6. Pass the cable through the cable gland (See
7. Insert the cable connector to the Ethernet port, then tighten the seal nut by hand until resistance is felt (when
the seal contacts the cable). Tighten with a spanner one further turn.
Figure 6
Software
For instructions on choosing operating modes and initial software configuration, refer to the AP Software Quick
Start Guide.
Aruba access points are classified as radio transmission devices, and are subject to government regulations of
!
the host country. The network administrator(s) is/are responsible for ensuring that configuration and operation
of this equipment is in compliance with their country's regulations. For a complete list of approved channels in
your country, refer to the Aruba Downloadable Regulatory Table at
https://www.arubanetworks.com/techdocs/DRT/Default.htm
Verifying Post-Installation Connectivity
The integrated LEDs on the access point can be used to verify that the access point is receiving power and
initializing successfully (see
on verifying post-installation network connectivity.
Electrical and Environmental Specifications
Aruba 570EX Series Hazardous Location Access Points
Cable Gland
Entry Item
Seal
Passing a Cable through the Cable Gland
Table 1
and
| Installation Guide
Seal Nut
Figure
6), then attach the connector to the end of the cable.
.
Table
2). Refer to the AP Software Quick Start Guide for further details
Figure
5.
9
Advertisement
Table of Contents
