Hardware Overview - Aruba IAP-367 Installation Manual

Hardware Overview

Figure 1 360 Series Access Point
LED
The 360 Series access point is equipped with one LED that indicates the system status of the device.
This LED can be configured via ArubaOS (for AP-365 and AP-367) or Aruba Instant (for IAP-365 and
IAP-367) software into three separate modes:
Normal mode (by default): See

Off mode: LED is off

Blink mode: LED blinks green (synchronized)

Table 1 360 Series LED Status during Boot Up
LED
System LED
Table 2 360 Series LED Status during Operation
LED
System LED
USB Console Port
The USB Micro-B console port allows you to connect the AP to a terminal or a laptop for direct local
management. Use the included USB console cable to connect the AP. You can download the
2
Table 1
Color/State
Off
Red
Green - Flashing
Green - Steady
Green - Yellow, 6 seconds
period
Color/State
Solid Red
One blink off every 3
seconds
Two quick blink off 0.5
seconds apart cycled every
3 seconds
Meaning
No power to AP
Initial power-up
AP booting
AP ready and 1000Mbps Ethernet link established. The LED
turns off after 1200 seconds
AP ready and 10/100Mbps Ethernet link established. The LED
turns off after 1200 seconds
Meaning
General fault
Radio 0 fault (5 GHz)
Radio 1 fault (2.4GHz)
Aruba 360 Series Outdoor Access Points
USB Console Port, Reset
button and LED
Grounding Point
Ethernet Port
Air Vent
| Installation Guide