Specification; Handheld Transmitter - JTS E-6 Instruction Manual

3. Specification

3-1 Receiver
Model No .........................................
Frequency Preparation..............
Carrier Frequency Range.......
S/N Ratio...........................................
T.H.D.............................................
Display........................................
Display Contents...........................
Controls............................
Audio Output Level....................
AF Output Impedance..............
Squelch.............................
Operation Voltage.........................
Output Connector.......................
Dimension(m/m)...............

3-2 Handheld Transmitter

Model No............................................
Frequency Preparation...............
Carrier FrequencyRange..........
RF Outputs........................................
Stability..................................................
Frequency Deviaion....................
LED Display.......................................
Controls................................................
Spurious Emissions.......................
Audio Frequency Resonse.......
Battery.....................................................
E-6
PLL Synthesized Control
470~960 MHz
> 105dB
<0.6%@1KHz
LED
Antenna A/B, RF/AF Status
Power On/Off, Channel Selecting, Audio Level
-12dB
600Ω
Pilot Tone, Noise and Mute
12-18 VDC, 150mA
1 Balanced XLR socket
1 Unbalanced Ø6.3mm phone jack
221mm (W)* 40mm (H)* 152mm (D)
E-6TH
PLL Synthesized Control
470~960 MHz
10mW
±10KHz
±48KHz
Power On/Off, Low battery
Power On/Off, Channel Selecting (Round Switch)
<-60 dBC
50~16,000 Hz
UM3, AA 1.5V*2
2