Table of Contents
Advertisement
How to Remove Door
Use the glass latch tool to disconnect the spring latches from the glass
frame. Insert tool into hole in latch, pull towards you and rotate 90-
degrees to disengage top latches. Remove tool. There are two spring
latches on top of this gas fireplace. Always make certain the hook
glass latches are in the upside-down position after removing the glass
frame. This upside-down latch position will make it easier to reinstall
the glass frame later.
With both hands, rotate top edge of glass frame away from unit,
approximately 8".
Lift glass frame up 1", at an angle, and move away from unit.
Door is now free from unit.
NOTE: Always check glass gasket condition and gasket seal
any time the glass door is removed and when reinstalling
glass door.
How To Replace Door
1. Line up the two bottom tabs in glass frame bottom (left and right sides) with slots on the sides of the firebox bottom.
Insert tabs into slots and center tabs in slots, left to right.
2. Center glass frame over firebox; left to right.
3. After door has been placed into slots, rotate door towards firebox until gasket seal is touching the firebox frame.
4. Use the tool provided to connect the spring latches to the glass frame. Insert tool into hole in spring latch, pull latch
towards you, rotate latch so the hook is facing downward then release latch to hook to door frame.
Door is now connected and sealed to unit.
GLASS FRAME ASSY.
85-03-01113
SPRING LATCH
INSERT
TAB
IN SLOT
DETAIL A
DXV35DT4
Insert Tab in slot
Page 51
Advertisement
Table of Contents
