Table of Contents
Advertisement
PF2 Ignition System Diagram
Note: Connect wires in junction box located on the right
side of this appliance to house power using supplied wire
nuts.
Note: On Décor models, the Split Flow circuit is
not installed nor used.
Replacement wires must have the same type and size of
insulation as the original.
85-03-01113
This appliance must be electrically connected and grounded
in accordance with local codes or, in the absence of local
codes, with the current NFPA 70- National Electric Code or
CSA C22.1- Canadian Electrical Code.
Label all wires prior to disconnection when servicing control.
Wiring Errors can cause improper and dangerous operation.
Verify proper operation after servicing.
DXV35DT4
Page 41
Advertisement
Table of Contents
