Advertisement
Vibration and noise emission
Sound pressure level: 91 dB(A), K=3 dB
Sound power level: 102 dB(A), K=3 dB
Vibration: ah=11.4 m/s², K=1,5m/s
Information:
The declared vibration total value has been measured in accordance with a standard test
method and may be used for comparing one tool with another;
The declared vibration total value may also be used in a preliminary assessment of
exposure.
Warning:
that the vibration emission during actual use of the power tool can differ from the
declared total value depending on the ways in which the tool is used; and
of the need to identify safety measures to protect the operator that are based on an
estimation of exposure in the actual conditions of use (taking account of all parts of the
operating cycle such as the times when the tool is switched off and when it is running idle
in addition to the trigger time).
Wear hearing protection.
3. USE
Fitting the sandpaper
IMPORTANT: Switch off the tool and unplug the power cord before fitting the sandpaper.
1. The sandpaper pad has a Velcro surface for the quick attachment of sandpaper. Brush off
any dust from the Velcro surface.
2. Smooth the sandpaper onto the pad.
3. Align the holes in the sandpaper with the holes in the pad.
Dust extraction
Connect the dust bag so that it locks in place.
If to Connect a Vacuum cleaner, first use the Connection(7)
NOTE: Dust extraction only works when there are holes in the sandpaper.
Starting/stopping
Connect the eccentric sander to the power supply.
Starting Press the switch " I "
Stopping Press the switch " O ".
Sanding
1. Place the sanding surface flush with workpiece.
2. Start the tool and move it over the workpiece with circular movements. Do not press the
tool. The
weight of the tool normally produces the right speed and sanding action. Avoid tilting the tool.
3. Continue sanding with finer grades of sandpaper.
Polishing
Apply the polish evenly, allow to dry and then start polishing.
When you have finished, lift the tool slowly from the workpiece before switching off.
MAINTENANCE
4.
Clean the dust extraction holes regularly with a dry brush.
2
Advertisement
