Table of Contents
Advertisement
10-EXTRACTING INSERT AND LOADING PELLETS IN COLD MACHINE
EXTRACTING INSERT AND LOADING PELLETS
SLIDE VERSION
The insert can be extracted in order to load pellets into the tank and perform routine maintenance (clean the ash pipe at the end of the
year) or special maintenance (replacement of electrical parts if the product breaks)
Follow the procedure below to extract the insert:
•
open the fire door "C" using the cold handle "Z" supplied
•
for the SLIDE version, still using the cold handle "Z", rotate the bottom handle "M" to the right
•
to extract the movable part (in the SLIDE version), use the handle "I"
Caution! You must slightly force it to extract the product.
Caution! A safety device allows the insert to be extracted, which must occur only when the machine is completely
cold. If the machine is not completely cold, it cannot be extracted.
When loading, do not let the pellet bag come into contact with hot surfaces.
No other type of fuel other than pellets is to be inserted into the hopper, in compliance with above-mentioned
specifications. Store the spare fuel at an adequate safe distance.
Do not pour pellets directly onto the brazier but only into the hopper.
When the appliance is running and when it is turned off, most of the stove surfaces are very hot (door, handle, glass,
smoke outlet pipes, etc.). Therefore it is recommended to avoid coming into contact with these parts.
Fuel is loaded using the front drawer, which can be found above the door in the BASIC version, at the top when the insert is extracted in
the SLIDE version, whereas with the LINK kit installed on the SLIDE version insert, pellets are loaded through the door to the side or above
the insert at the front.
Once the insert is extracted, fill to the brim and then press towards the inside of the tank to compact the pellets. Before putting the cover
back in place, make sure there are no pellet pieces in the cover support zone.
50
BOXTHERM SLIDE
C
Z
I
M
Advertisement
Table of Contents
