Table of Contents
Advertisement
Bending up the shipping clips
If your product employs shipping clips, once the unit is detached from the pallet by removing the securing lag screws that hold
these shipping clips to the pallet, either bend these clips up 90-degrees or break them off using a screw driver and back and
forth cold working motion (see below). A bending relief is provided within the clip to ease bending or breaking. Bending the
shipping clips up or removing them will be necessary for Fireplace units which are to be installed in narrow width or shallow
depth openings.
To bend the clips up or to break them off, follow these procedures:
1. Insert the tip of a flat screwdriver (longer screwdriver is better) under the clip.
2. Lift screwdriver handle upwards and bend the clip up about 45-degrees.
3. Remove screwdriver. Insert screwdriver tip into one hole in clip. Lift screwdriver up. To break clip off, repeat up down
motion of screwdriver seven to eight times.
Figure 4-4 Shipping Clip
STEP 1 & STEP 2
STEP 3
Figure 4-6 Bend Up Clip 2
Figure 4-5 Bend Up Clip 1
Page 49
85-03-01116
DXV42 TIMBERFIRE
Advertisement
Table of Contents
