Routine Hepa Filter Inspection; Inspecting & Cleaning; Oven Chamber Interior; Oven Exterior - Despatch LCC Series Owner's Manual

C244, 320207, REV B
3. If not, contact ITW EAE - Despatch.
Refer to Protocol 3 manual for more details.

7.14. Routine HEPA Filter Inspection

Perform initial inspection on HEPA filters before installation and periodically
afterwards. Section 5.3.1 provides details on HEPA filter handling and inspection
prior to installation. Following routine inspections are recommended once filter is
put in service.
1. In general, inspect for cracks, breaks or pinholes. Replace as necessary (See
Section 7.16.3 for a list of some of the conditions that warrant filter
replacement).
2. Measure the pressure drop across the HEPA filter. An increase in static
pressure drops of more than double that of the filter's initial static pressure
drop measurement is observed, ITW - Despatch recommends replacing the
filter. Refer also to Instructions V-30, HEPA Filter Instructions, online at
www.despatch.com
procedures.
7.15. Inspecting & Cleaning

7.15.1. Oven Chamber Interior

Keep perforated panels/louvers and other surfaces of the chamber clean. Use a
vacuum cleaner to clean perforated panels.

7.15.2. Oven Exterior

Clean oven exterior with general purpose light detergent and water. Do not clean
while the oven is hot. Do not use abrasives or chemical solvents.

7.15.3. Vents

Make sure intake and exhaust openings are clean and free of blockages. Any dirt
accumulation in the air circuit can unbalance temperatures and airflow patterns.
72 of 82 ©2021 ITW EAE. All rights reserved. Despatch is a registered trademark in the U.S. and other
countries. No part of the contents of this manual may be reproduced, copied or transmitted in any form
or by any means without the written permission from ITW EAE - Despatch, unless for purchaser's
personal use.
for details on replacement requirements and installation
LCC_LCD1-16/51 Oven Owner's Manual