Figure 13. Open The Front Panel For Access - Despatch LCC Series Owner's Manual

C244, 320207, REV B

The oven must be hardwired directly to the disconnect switch on
the equipment panel (Figure 14).
Danger!
All grounding and safety equipment must be in compliance with
applicable codes, ordinances and accepted safe practices.
A conduit fitting for customer power line is located on the rear left of the oven
(Figure 14).This conduit runs up to the front control panel, where wires can
terminate at the disconnect switch.
• Run line voltage power through the conduit from rear of oven to front (Figure
14). Consult electrical drawings included with the oven for details (Section 9.4).
• Access the conduit and Disconnect Switch by opening the front panel (Figure
13).
• Connect the line voltage power to the disconnect switch labeled LINE
CONNECTIONS (Figure 14).
42 of 82 ©2021 ITW EAE. All rights reserved. Despatch is a registered trademark in the U.S. and other
countries. No part of the contents of this manual may be reproduced, copied or transmitted in any form
or by any means without the written permission from ITW EAE - Despatch, unless for purchaser's
personal use.

Figure 13. Open the front panel for access.

LCC_LCD1-16/51 Oven Owner's Manual