Snapmaker Dual Extrusion 3D Printing Module Quick Start Manual page 8

2.1 Scenario 1: Enclosure Not Installed on the Machine
If the Enclosure is not installed on your machine, follow the corresponding
steps below to install the Dual Extrusion Module and the Filament Holder(s) in
accordance with your machine models.
14
2.1.1 A150
01
/03
Attach the Dual Extrusion Module to the slider on the X
axis.
Dual Extrusion
Module
×1
Machine Assembly
M4×8 Screw ×4
Make sure the power switch
is in the Off position.
15