7.1 CONNECTING THE BATTERY CHARGING CABLE:
6
(1). before connecting the Battery Charging Cable 1 to a battery that is
installed in a vehicle, disconnect the vehicle battery ground cable from
the negative (-) battery terminal.
(2). Plug the Battery Charging Cable 1 into the 12V DC Receptacle 2 of
the generator.
(3). Connect the Red Charger Jack 4 to positive (+) battery terminal and
the Black Charger Jack 5 to negative (-).
(4). Turn the ECO Switch 3 to the "OFF" position.
(5). Start the engine to charge the battery.
(6). Charging time will vary with battery size and condition.
Circuit Breaker 6 does not prevent over-charging a battery.
NOTE
⚫
The 12V DC Receptacle should ONLY be used for charging 12V
automotive type batteries. The 12V DC output is unregulated
and will damage other 12V DC products.
⚫
When using the 12V DC output, turn the ECO Switch to the
"OFF" position.
1
3
2
1
- 44 -
4
5
The DC