Huawei SmartLi 2.0 User Manual page 57

SmartLi 2.0
User Manual
2.
3.
Step 10 Pull out the BCU for about 10 cm and measure the battery module voltage to
check whether the recharge meets requirements.
Table 4-3 Voltage requirement and method for measuring voltage after recharge
Battery Type
ESM-6440P1
Step 11 Remove the battery module cables, place the battery module in the original
packing case, and update the latest charge time and next charge time on the
recharge label of the original packing case. The battery module should be used as
soon as possible.
Step 12 Reinstall the BCU.
Figure 4-3 Installing the BCU
----End
Recharge with a Portable Battery Charger/Discharger
Step 1 Verify that the battery modules to be recharged meet the model requirements and
are free from deformation, damage, and leakage.
Step 2 Check that the power supply to the portable battery charger/discharger is
disconnected.
Issue 13 (2023-03-26)
Hold down the POWER ON/OFF button on the BCU for more than 5s to
power off the SmartLi.
Turn off the ready switch on the BCU.
Required Voltage After
Staying in Open-Circuit State
for 10 Minutes Following
Recharge
≥ 65 V
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Transportation and Storage Requirements
Method for Measuring
Battery Voltage
Use a voltmeter to measure
the voltage between the
positive and negative
terminals of the battery.
48