Huawei SmartLi 2.0 User Manual page 106

SmartLi 2.0
User Manual
Figure 5-56 Pulling out the BCU
Step 3 Install battery modules.
Figure 5-57 Installing battery modules
Step 4 Remove the front cover of the battery module, install the battery baffle plate, and
tighten the two screws. Check the insulation performance of the battery module.
Set a multimeter to the DC voltage mode and measure the voltage between the
positive and negative terminals of each battery module and the screws on the
battery baffle plate respectively. If the readings are less than 6 V DC, the
insulation is good. Otherwise, contact technical support engineers.
Place the front covers properly to prevent the light pipes from falling off.
Issue 13 (2023-03-26)
NO TICE
Copyright © Huawei Digital Power Technologies Co., Ltd.
5 Installation and Cable Connection
97