Huawei SmartLi 2.0 User Manual page 56

SmartLi 2.0
User Manual
Figure 4-1 Switching off the battery circuit breaker
Step 3 Install the battery modules and cables.
Step 4 Press and hold the POWER ON/OFF button on the BCU for more than 2s until the
green indicator of the BCU blinks at short intervals (on for 0.25s and off for 0.25s).
Figure 4-2 POWER ON/OFF button and green indicator
Step 5 Set parameters on the touchscreen Settings Wizard on the SmartLi cabinet.
Step 6 After the green indicator on the BCU blinks at super short intervals (on for 0.1s
and then off for 0.1s) and the red indicator is steady on, switch on the battery
circuit breaker in the upper part of the SmartLi cabinet to power on the SmartLi.
Step 7 Check that the battery modules to be charged have been discharged.
Step 8 Observe the charging status of the battery modules in real time until the charging
is complete (the battery module SOC displayed on the touchscreen reaches 50%).
Step 9 Power off the SmartLi when the charging termination condition is met.
1.
Issue 13 (2023-03-26)
Switch off the battery circuit breaker in the upper part of the SmartLi.
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Transportation and Storage Requirements
47