Huawei SmartLi 2.0 User Manual page 117

SmartLi 2.0
User Manual
During the power-on procedure, power off the batteries immediately if any fault is
detected. Rectify the fault before proceeding with the procedure.
Fully charge batteries (the SOC must reach 100%) before using them for the first
time. Replace a battery only if it is faulty.
Step 1 Start the BCU. The status of the running indicator and fault indicator on the BCU
changes accordingly, as described in
●
●
Table 6-1 BCU indicator status change
Change
Order
1
2
3
Step 2 On the SmartLi LCD, set the language, time, date, network parameters, and
system parameters on the Settings Wizard screen, and tap Finish.
Obtain network parameters from the customer.
Issue 13 (2023-03-26)
CA UTION
CA UTION
Single SmartLi cabinet: Hold down the POWER ON/OFF button on the BCU of
the SmartLi for more than 2s.
Multiple SmartLi cabinets are connected in parallel: Hold down the POWER
ON/OFF button on the BCU of each SmartLi for more than 2s.
Indicator Status
Running indicator (green):
blinking at short intervals (on for
0.25s and off for 0.25s)
Running indicator (green): blinks
intermittently (on for 1s and off
for 4s)
Running indicator (green): blinks
at super short intervals (on for
0.1s and then off for 0.1s)
Fault indicator (red): steady on
NO TICE
Copyright © Huawei Digital Power Technologies Co., Ltd.
6 Power-On and Commissioning
Table 6-1.
Description
The power button is pressed.
Standby state. The SmartLi
circuit breaker cannot be
switched on.
Standby state. The SmartLi
circuit breaker can be switched
on. If the fault indicator is steady
red, a BCB off alarm is displayed
on the LCD of the SmartLi, and
no action is required. The alarm
will disappear after the battery
circuit breaker is switched on.
108