Switching On; Switching Off - OCULUS Pentacam AXL Instruction Manual

7 Setup and Connection
7.2

Switching On

7.3

Switching Off

20 / 85
Note
Risk of equipment damage due to incorrect connection
If you do not connect the Pentacam® AXL properly, and the connection is
live, the unit can be damaged within a short period of time.

Do not use excessive force when connecting the electrical plug.

Pay attention to the specifications on the nameplate.
If the electrical plug is damaged, contact our service department or an
authorized distributor to repair the damage.

Firmly tighten the connection.

Connect the Y-cable to the PC/laptop and the power adapter.
Attention
Risk of incorrect measurements due to improper setup

Before taking measurements, the Pentacam® AXL has to be switched
on, at least for one hour.

The first step is to switch on the PC or laptop.

Then turn on the Pentacam® AXL with the on/off switch (position
ON). The LED on the switch lights up green,

Close the Pentacam® AXL program and close the Patient Data
Management.

Shut down the Windows operating system.

Turn the Pentacam® AXL off with the on/off switch (OFF position)
Instruction Manual Pentacam® AXL (G/70100/EN 1121 Rev04)
fig. 7-1, page 19.