Operation; Switching On; Switching Off; Daily Operation - OCULUS Myopia Master Advanced Instruction Manual

9 Operation

9 Operation
9.1

Switching On

1
9.2

Switching Off

9.3

Daily Operation

20 / 92

Wait approx. 3-4 hours after transport before operating the Myopia
Master® for the first time. Extreme temperature changes from cold
areas to warm rooms can cause condensation on the optical
components.

Turn on the Myopia Master® with the On/Off Switch (position I). The
LED lights up green.

End the current session.

Turn the Myopia Master® off with the on/off Switch (position 0).
Caution
Risk of electric shock if the Myopia Master® is not completely
disconnected from the mains for transport, cleaning, maintenance,
disinfection and repair.

Turn the Myopia Master® off.

Pull the power plug before cleaning. When disconnecting electrical
connections, pull on the respective plug and not on the cable itself.
If you move the Myopia Master® to another location, you must position
the Myopia Master® so that direct light cannot influence measurements.

Place the Myopia Master® on a level surface.

Connect the unit to the mains with the supplied power cable.

Make sure that the mains voltage is the same as the voltage
specified on the rating plate.

Switch on the Myopia Master® at the On/Off Switch, see
page 20.
Instruction Manual Myopia Master® (G/68100/EN Rev04 0820)
sec. 9.1,