Electrical Connection - OCULUS Pentacam AXL Instruction Manual

7.1

Electrical Connection

Instruction Manual Pentacam® AXL (G/70100/EN 1121 Rev04)
Attention
Electrical safety hazard

Do not use the Pentacam® AXL adjacent to or stacked with other
equipment.

If you have to use the Pentacam® AXL adjacent to or stacked with
other equipment, verify the correct operation of the Pentacam® AXL.

Only use the power adapter listed in the list,

If you use a power strip to connect the Pentacam® AXL: Use a power
strip that complies with the requirements of DIN EN 60601-1.

Do not place the multiple socket extension cord on the floor.

Do not use more than one multiple socket extension cord.

Plug only the Pentacam® AXL and the computer that is being used
with the unit (if applicable) into the multiple socket extension cord.

Use a socket with a protective earth connection which is fully
operating.
Fig. 7-1:
Connecting

Plug the connector of the Y cable into the jack and tighten the
connection. Make sure that the plug is inserted in the correct position.
7 Setup and Connection
sec. 20.1, page 75.
19 / 85