System Requirement; Mains Power; System Setup; Pc Connection - OCULUS Easyfield Service Manual

The device EASYFIELD is controlled by a
standard PC or with the handheld unit. If
controlled by a PC (or Laptop) it must have
the following requirements:
• PC 486DX4 min. 100 MHz
• RAM 16 Mbytes
• Harddisk min. 1.7 Gbyte
The power supply needs AC Voltage 100-
240 Volt ~, 50Hz - 60Hz, 0,75A – 0,35A.
Output: +12V =, 2,75A.
The Easyfield works with a standard RS232
serial interface with 115200Baud.
Caution: Do not connect or disconnect any
cable while the PC or the Easyfield is
switched on!
If the Easyfield should work with the PC
connect the unit with the PC by using a
Service manual Easyfield
3

System requirement

3.1 PC
• Windows
95/98/ME
• VGA 640*480 Pixel with min. 256
Colors

3.2 Mains power

4

System setup

4.1 PC connection

4.2 Wiring

9 pin (one to one) extention cable (D plugs).
Connect the Easyfield unit with the power
supply.
page 4
NT/2000/XP, Windows