Support Software; One-To-One Computer Connections - Omron SYSMAC CPM2B-S001M-DRT Operation Manual

System Configurations
1-2-4
1-2-5
RS-232C Port Connection
IBM PC/AT or
compatible computer
10
Downloaded from Elcodis.com electronic components distributor

Support Software

A personal computer running the CX-Programmer or SYSMAC-CPT Support
Software (in MS Windows) or the SSS (in MS-DOS) can be connected to the
CPU Board's Peripheral port or RS-232C port. Refer to 1-2-5 One-to-one
Computer Connections for details on the computer connection.
The setting of DIP Switch pin 3 determines whether the communications set-
tings in the PC Setup or the standard settings will be used, as shown in the
following table.
Pin 3
setting
ON
OFF
When using the SSS, set the PC Model to "CQM1." When using the SYS-
MAC-CPT, set the PC Model to "CQM1" with the "CPU43" CPU version.

One-to-one Computer Connections

Use one of the connecting cables shown in the following diagram to connect a
personal computer with Support Software to the CPM2B-S for a 1:1 Host Link
communications or no-protocol (serial) communications.
Connecting Cable
XW2Z-200S-V (2 m)
XW2Z-500S-V (5 m)
RS-232C port
(D-sub 9-pin)
IN000CH IN001CH IN002CH
OUT010CH OUT011CH OUT012CH
CPM2B-S CPU Board
Note 1. The CQM1-CIF11 Connecting Cable cannot be used.
2. Refer to Appendix A Standard Models for details on the Support Software
that can be used with the CPM2B-S.
Communications settings
Peripheral port
Standard settings (The standard settings and PC Setup default settings
are Host Link communications at 9,600 bps with 1 start bit, 7-bit data, 2
stop bits, and even parity.)
PC Setup settings in DM 6650 and
DM 6651
Peripheral Port Connection
IBM PC/AT or
compatible computer
Connecting Cable
XW2Z-200S-V (2 m)
XW2Z-500S-V (5 m)
Section 1-2
RS-232C port
PC Setup settings in DM 6645 and
DM 6646
CQM1-CIF02
(3.3 m)
CS1W-CN114
(0.05 m)
Peripheral port
IN000CH IN001CH
OUT010CH OUT011CH
CPM1-CIF01
RS-232C Adapter
CPM2B-S CPU Board
IN002CH
OUT012CH