Omron SYSMAC CPM2B-S001M-DRT Operation Manual page 54

Wiring and Connections
MIL Loose-wire Pressure Connector
Using Relay Terminal and
Terminal Blocks
Assembling and Wiring
Input Connectors and
Output Connectors
42
Downloaded from Elcodis.com electronic components distributor
Available Connectors and Cables
Name
Socket
Strain Relief
Set (Socket + Strain Relief)
Recommended Flat Cable
OMRON Crimping Tools
Crimping Tool
Attachment
Note Two Full Covers or Partial Covers are required for each socket.
Available Connectors
Socket
Full Cover (2 required for each Socket)
Partial Cover (2 required for each Socket)
OMRON Pressing Tools
Pressing Tool Set (Handy Press)
Simple Pressing Tool
A G79-A C (Loose-wire Connecting Cable) can be used to connect to a
@
Relay Terminal. (A pressure connector must be attached on the PC side of the
cable.)
A special cable is not provided for connection to the XW2B-20G4 or XW2B-
20G5 Terminal Blocks, so one must be made. (The Terminal Block requires
the kind of MIL 20P connector described above.)
MIL40 Flat Cable Connector
Follow this procedure when assembling your own connecting cable using flat
cable and XG4M-4030-T MIL Connectors.
1,2,3... 1. Use a slotted precision screwdriver to release the hooks on the sides of the
connector and separate the MIL socket's contact and cover pieces.
There are two tabs on each side of the socket (contact piece). Do not try
XG4M-2030
XG4T-2004
XG4T-2030-T
XY3A-200
@
XY2B-0002
XY2B-1007
Full Cover (See note)
Partial Cover (See note)
Sockets
Name
AWG 24 XG5M-2032-N
AWG 26 to 28 XG5M-2035-N
XG5S-2012
XG5S-1001
XY2B-2104
XY2B-7006
Section 3-5
Model number
Model number