Introduction; General Installation Conditions - ESDEC CLICKFIT BASIC Manual

1. Introduction

This manual describes the installation of the ClickFit mounting system comprising of a double layer cross-cross
arrangement for a corrugated roof. (for solar panels in portrait setup)
Read the manual carefully so you are fully informed of the contents of the manual. Follow the instructions in the manual
carefully. Perform the operations in the correct order.
Keep the manual in a safe and dry place. Should the manual get lost then there is the possibility to request a new one from
Esdec BV.

2. General installation conditions

In general
Non-compliance with the requirements mentioned in this document may result in invalidation of all warranty and product liability claims.
The data, comments and opinions in this document are binding and must be checked for completeness and timeliness.
Esdec BV reserves the right to modify this document without notice.
Stability and condition of the roof
The roof should be in good condition and strong enough to bear the weight of the solar panels incl. the additional materials, wind and
snow loads. Check the stability of the roof and adjust the roof / construction where necessary, in in doubt contact a manufacturer. Ensure
that the load reserve of the roof is exceeded not locally or in its entirety.
Safety Warnings
•
Before starting the installation, you should be informed of which material the corrugated iron is manufactured. If the concerned
corrugated iron is contains asbestos, we refer to the law and regulations concerning working with asbestos containing materials.
•
The installation of the ClickFit mounting system should standard be performed by qualified technical personnel (at least 2 skilled
people).
•
Adding or removing parts may have an adverse effect on the functioning and is not advised!
•
For placement of the solar panels the roof should be clean, dry, flat and free from algae etc.
•
Avoid mounting with strong winds and a slippery wet roof surface.
•
Work on a pitched roof alwaays with fall protection, and if necessary with safety nets and edge protection.
•
Wear shoes with reinforced toe and sturdy non-slip soles.
•
Always wear proper protective clothing when performing the work.
•
Always use a lifting aid / lift installation when moving the equipment (solar panels, etc.)
•
Always place a ladder on a firm stable surface.
•
Always place the ladder at an angle of about 75º and leave it sticking out about 1m above the roof edge.
•
If possible, secure the ladder to the top with a rope or strap.
•
Preferably work according to manual "work safely on roofs".
Scope ClickFit
•
Wind zone (1 t/m 3)
•
Roof height (3-9m) When your roof is higher you should contact your supplier.
•
Type of roofing: Corrugated iron
•
Roof pitch: Between 15 - 60 degrees (35 degrees is best)
Edge zone
The distance from the solar panels to the ridge and gutter should be at least 30 cm due the wind load.
The distance from solar panels to the side of the roof should be at least 30 cm. There shouldn't be solar panels in this area, in its entirety
nor in part.
Dimensioning
All dimensions and sizes are in cm unless stated otherwise.
Rev. 10.06.15 MANUAL MOUNTING SYSTEM FOR CORRUGATED ROOF
01