2. Spare parts replacement
► Precautionary measures
» Always unplug the machine to turn off the power before opening it.
» Turn off the water tap and disconnect the water supply hose.
» The service area can have sharp edges, wear gloves and long sleeves.
» When the Bolero is drained, water out of the drain hoses can be hot, therefore take protective measures.
Necessities:
• Philips screwdriver
• screwdrivers torx 10 and 15
• curved nose pliers
Reassembly remarks:
• see the exploded views for the service part numbers
• see the electric diagram for the wiring connections
► This chapter is based on the Bolero 43, the same procedures can be used for the Bolero 11, 21, 33 and 42 as well.
Should the procedure be different for another type such as the Bolero 43, it is indicated separately
2.1 Remove the door safety switch
A
A
2
D
C
A
B
A
Step 1
• open the door
• remove the 4 screws
A
• remove the cover of the print
C
• remove the 2 screws
• remove the safety switch
• disconnect the connector of the wiring
of the print cover
B
of the safety switch bracket
D