Instruction Manual English 1.1 Introduction We are delighted that you have chosen 1.8.1 In general............6 1.8.2 Activating the settings program ......6 one of our quality products, the Bolero F. 1.8.3 Closing the settings program......6 These machines are specially designed 1.9 S .........7 STEP PROGRAMMING for making hot beverages such as coffee,...
∆ The manufacturer accepts no liability for • All repairs must be performed by the any damage resulting from installation, Bravilor Bonamat dealer or a skilled and use or maintenance that is not in authorised expert. compliance with this manual.
1.4 A quick machine guide The double page presents the most 1.4.1 CCESSORIES important parts of the machine. Keep this • Renegite double page unfolded & while reading • Funnel this instruction manual. • Water connection hose 1. On/off switch of the machine •...
1.5 Installing the machine and setting up for operation 1. Place the machine on the work 18. Lock the door with the key (20). surface. Leave a minimum of 6 cm 19. A flashing thermometer will appear in clear on the right-hand side so that the top right-hand corner of the the door (10) can be opened.
1.6 Installing the machine and setting up for operation (continued) 32. Place an empty decanter under the 35. The beverage maker is ready for use beverage outlet (14) and push the when the quantity of the full decanter selection key (12) twice to also is satisfactory.
1.8 General programming procedure 1.8.1 5. Attention! These counters will be N GENERAL repeated three times than the Before you start programming, remember program returns to normal mode. If which settings have to be changed. this happens just press again the Make a note of the settings you wish to programming button (3).
1.9 Step-by-step programming 1.9.1 CARE! Water that is leaving the hose TARTING THE RINSING PROGRAM may be hot! 8. Remove the drain plug of the drain hose (5) to allow the water out into the drain or the bucket. 9. Replace the plug on the hose. 10.
1.10 Step by step programming (continued) 25. Halt the descaling program 1.10.2 S ETTING THE QUANTITY OF BEVERAGE immediately after Point 5: PER SEMI DECANTER Within 5 seconds: Fig. 9 Fig. 7 1. Select program 'setting quantity per The descaling program can be semi decanter'.
1.11 Step by step programming (continued) 1.11.1 S 1.11.3 S ETTING THE STRENGTH OF BEVERAGE WITCHING THE MIXER ON OR OFF WHEN TAPPING SEMI DECANTERS Both in drawing off semi - as well as full decanters, you can choose to switch the mixer on or off.
1.12 Step by step programming (continued) − press on the right-hand side of the 1.12.1 S ETTING THE TEMPERATURE OFF THE ß for a higher water setting key HOT WATER BUFFER STOCK temperature. − press on the left-hand side of the setting key à...
1.13 Usage 1. Insert the plug into an earthed wall 18. Place an open and empty decanter socket. under the beverage outlet (14) when 2. Open the door (10) on the left-hand the semi - or full decanter setting is side with the key (20).
1.14 Maintenance It goes without saying that the machine 1. Remove the mixer (4.6) at the and the accessories have to be kept same time as the base plate thoroughly clean. (4.7) by turning it to the right and pulling it forward. 1.14.1 D 2.
1.15 Descaling When this descaling signal is activated PRECAUTIONARY MEASURE (fig. 1 appears in the display), the • Stay with the machine throughout the descaling program § 1.9.2 must be started soon. descaling process. • Wear gloves and a facial protector Before descaling read the instruction while descaling.
If the machine needs to be opened, e.g. help to resolve the problem, consult your in the case of repairs, the plug must first Bravilor Bonamat dealer, your service be removed from the wall socket! engineer or one of the service centres.
Page 18
Model : ........Type : 8 . Vlgnr. : .......VHH ....V 50/60HZ....W Blr010F-001/Blr011F-001 - 16 A L= ± 120 cm min. 1 bar/max. 10 bar...
Need help?
Do you have a question about the Bolero 10 F and is the answer not in the manual?
Questions and answers