Remove The Temperature Sensor (Ntc Resistor); Remove The Boiler - BRAVILOR BONAMAT Bolero Series Technical Manual

2.11 Remove the temperature sensor (NTC resistor)

B
B

2.12 Remove the boiler

A
C
B
D
H
I
8
A
A
C
B
B
A
D
A
E E
F
H
I
G
Step 1
• remove the back panel as in Step 1
Step 2
► Be careful some boiler parts can be hot.
• disconnect the wiring from the I/O board
• remove the bolt of the temperature sensor
A
• remove the temperature sensor
► See the electric diagram for the connection on the I/O
board.
Step 1
• remove the drip tray
• pull out the draining hose
• place a container under the drain hose
• remove the tightening plug
• wait until all the water has drained out of the boiler
• replace the tightening plug
Step 2
• remove the back panel as in Step 1
Step 3
• remove the temperature sensors from the boiler
• remove the wiring of the temperature safety switches
B
• remove the hose on top of the boiler
• remove the 2 screws
D
• disconnect wiring of the element
boiler
• pull the boiler supply
• remove the boiler
Step 4
• pull the silicone ring
G
• remove the temperature safety switches
• remove the isolation parts
of section 2.4
B
A
B
C
of section 2.4
C
of the mounting brackets
underneath the
E
out of the boiler
F
out of the boiler
H
I
A