Home Decorators Collection OSSA CF2001-N Use And Care Manual page 10

Assembly - Hanging the Fan (continued)
8
Install the light housing
□
Remove one screw from the connect plate (J) of fan-motor
assembly (B). And loosen other 2pcs screws away from 3/4 length.
□
Locate the key hole of light housing (E).
□
Place two key holes on the mounting screw loosened on the
connect plate (J).
□
Reattach 1pc screw through light housing (E) in place to the
connect plate (J).
□
Tighten 3pcs screws until light housing (E) is secure.
E
CAUTION: To reduce the risk of electric shock, disconnect the
electrical circuit to the fan before installing light kit.
J
Key hole
10
9
Install the LED module
□
Remove 3pcs pre-installed screws from inside of the light
housing (E).
□
Connect the terminal from LED module (F)and fan-motor assembly (B).
□
Locate 3pcs screw holes of LED module (F).
□
Place three screws holes between LED module (F) and light housing (E).
□
Reattach 3pcs screws through the screw holes of LED module (F).
□
Tighten the screws until LED module (F) is secure.
F
E
screws