Emerson Rosemount 928 Reference Manual page 25

Reference Manual
00809-0100-4928
3. On the Basic Setup screen, select Next.
4. Select Finish.
2.7.2 Joining the transmitter to a wireless network
To communicate with the Wireless Gateway and the host system, you must use the
wireless network to configure the transmitter.
This procedure is the wireless equivalent of connecting wires from a transmitter to the host
system. Using Field Communicator or AMS Wireless Configurator, enter the network ID and
join key so that they match the network ID and join key of the Wireless Gateway and other
devices in the network. If the network ID and join key are not identical, the transmitter will
not communicate with the network. You can obtain the network ID and join key from the
Wireless Gateway on the Setup → Network → Settings page on the web server.
Note
The amount of time required to join the new device or devices to the network is dependent
on the number of devices being joined and the number of devices in the current network.
One new device joining an existing network with multiple devices may take up to five
minutes. Multiple new devices joining an existing network may take up to 60 minutes.
Rosemount 928
Configuration
February 2023
25