Maintenance - jbc NAE Series Instruction Manual

Maintenance

Before carrying out maintenance, always switch the device off and disconnect it from the mains.
Allow the equipment to cool down.
- Clean the station screen with a glass
cleaner or a damp cloth.
- Use a damp cloth to clean the casing
and the tool. Alcohol can only be used
to clean the metal parts.
- Periodically check that the metal parts
of the tool and stand are clean so that
the station can detect the tool's status.
- Maintain the tip surface clean and
tinned prior to storage in order to avoid
tip oxidation. Rusty and dirty surfaces
reduce heat transfer to the solder joint.
- Periodically check all cables and tubes.
- Replace any defective or damaged pieces.
Use original JBC spare parts only.
- Replace a blown fuse as follows:
1. Pull off the fuse holder and remove the
fuse. If necessary use a tool to lever it off.
- Repairs should only be performed by a JBC authorized technical service.
12
Clean periodically
2. Press the new fuse into the fuse holder
Fuse holder
and replace it in the station.
Fuse holder
Fuse