Maintenance - jbc DIU Instruction Manual

Maintenance

Before carrying out maintenance, always switch the device off and disconnect it from the mains.
Allow the equipment to cool down.
- Clean the station screen with a glass
cleaner or a damp cloth.
- Use a damp cloth to clean the casing and
the tool. Alcohol can only be used to clean
the metal parts.
- Periodically check that the metal parts of
the tool and stand are clean so that the
station can detect the tool status.
- Maintain tip surface clean and tinned prior
to storage in order to avoid tip oxidation.
Rusty and dirty surfaces reduce heat
50 mm
transfer to the solder joint.
- Periodically check all cables and tubes.
40 mm
- Replace any defective or damaged pieces.
Only use original JBC spare parts.
- Repairs should only be performed by a
JBC authorized technical service.
- Replace a blown fuse as follows:
1. Pull off the fuse holder and remove the
fuse. If necessary use a tool to lever it off.
2. Insert the new fuse into the fuse holder
and return it to the station.
EARTH
- When this warning appears on
FUSE
the main screen Earthing Fuse must be
replaced
200 mm
130 mm
100 mm
80 mm
60 mm
TOOL
TOOL
clean periodically
AUX
Fuse
Fuse
holder
holder
Fuse
AUX
para manuales - color gris
130 mm
Clean
periodically
TOOL
9