Usb Connector; Maintenance - jbc DME Series Instruction Manual

USB Connector

Download the latest software from our website
to improve your soldering station at
www.jbctools.com/software.html.

Maintenance

Before carrying out maintenance or storage, always allow the equipment to cool.
- Clean the station screen with a glass cleaner
or a damp cloth.
- Use a damp cloth to clean the casing and the
tool. Alcohol can only be used to clean the
metal parts.
- Periodically check that the metal parts of the
tool and stand are clean so that the station can
detect the tool and establish its status.
40 mm
- Maintain tip surface clean and tinned prior to
storage in order to avoid tip oxidation. Rusty
and dirty surfaces reduce heat transfer to the
solder joint.
- Periodically check all cables and tubes.
- Replace a blown fuse as follows:
1. Pull off the fuse holder and remove the
fuse. If necessary use a tool to lever it off.
- Replace any defective or damaged pieces. Use original JBC spare parts only.
- Repairs should only be performed by a JBC authorized technical service.
200 mm
130 mm
100 mm
80 mm
60 mm
50 mm
Fuse Holder
para manuales - color gris
Clean periodically
2. Insert the new fuse into the holder and
return it to the station.
130 mm
Fuse
Fuse holder
9