Epson EpsonNet 10/100 Base Tx Int. 5e Manual page 45

7. Check the lights on the network interface. The orange status
light flashes and the green data light goes on. After a while,
the green or orange status light turns on and the data light
flashes.
8. To print a status sheet, press the status sheet button on the
network interface. Press the status sheet button once to print
a simple status sheet, or twice to print a full status sheet.
If the status sheet prints, this indicates the network interface
has been installed correctly.
c
Note for Mac OS X 10.2.4:
Since the device supports Rendezvous and is on by default, you can use
the device on a network just by connecting it to the network. If you want
to disable the Rendezvous setting, use EpsonNet Config.
Now, you can configure the network interface. See "Configuring
the network interface for Windows" on page 46 or "Configuring
the network interface for Macintosh" on page 51.
Chapter 1 Installing Components and Setting Up the Network Interface
Caution:
❏ Do not press the status sheet button while the orange
status light flashes and the green data light is on;
otherwise, the network interface will return to its factory
default settings, and the network status sheet will not
print correctly as well.
❏ After turning off the device, wait until the status lights
go off before turning it back on or before removing the
network interface; otherwise, the network interface may
not work correctly.
45