Table of Contents
Advertisement
The message "Could not complete communicating
configuration data" appears when you send settings to the
network interface.
Cause
This may happen when using
a dial-up router.
Unable to start EpsonNet Config with Web Browser.
Cause
You have not set the IP
address for the network
interface.
What to do
Run Command Prompt from the
computer on which EpsonNet Config is
installed, and then enter the following
command:
Format: >ROUTE_ADD_the IP address
of the network interface_ the IP address
of the computer (the under bar
represents one space)
Example: >ROUTE ADD 192.168.192.168
22.33.44.55.
What to do
Set the IP address for the network
interface using EpsonNet Config for
Windows or Macintosh, the printer's
control panel, or the arp/ping
commands. You can check the IP address
on a status sheet. See the EpsonNet
Config User's Guide or "Setting an IP
address using the arp/ping command"
on page 196.
Chapter 4 Problem Solver
204
Advertisement
Table of Contents
