Table of Contents
Advertisement
Unable to start EpsonNet Config.
Cause
You have added or deleted
protocols after installing
EpsonNet Config.
The message "Could not install the printer driver." appears
when you set up the network interface.
Cause
You have not installed the
printer driver.
The message "EpsonNet Config cannot be used because no
network is installed." appears when you start EpsonNet Config.
Cause
Both TCP/IP and IPX/SPX
are not installed on the
computer.
TCP/IP is installed on the
computer, but its IP address
is not set correctly.
What to do
Uninstall EpsonNet Config and then
reinstall it. See "Uninstalling software"
on page 200 and "Installing EpsonNet
Config for Windows" on page 92.
What to do
Install the printer driver on your
computer before setting up the network
interface. See "About installing the
printer driver" on page 58 or the manual
shipped with your printer for
instructions on how to install the printer
driver.
What to do
Install the TCP/IP or IPX/SPX protocol.
Set a correct IP address for the computer.
Chapter 4 Problem Solver
203
Advertisement
Table of Contents
