Table of Contents
Advertisement
(b) Transistor Outputs (Open Collector)
* To use these, various settings need to be configured. Refer to "8 Initial Setting Procedure".
24 VDC
Power
source
FG
Line Onsite
CN16
V+/ V-/ FG
24 VDC Power source
Tightening torque for terminal screws: 1 N·m
Note: The junction terminal CN40 is provided.
Use them as relay terminals if necessary.
X1
Ch1
/
CN06
CN40
ON/OFF,
(ON)
( ) is in the case of a pulse.
X2
Y1
Y2
Ch2
/
/
05
08
03
ON/OFF,
(OFF)
(ON)
(OFF)
9
Caution:
• When X1, X2, Y1 and Y2 relays are
used, select ones that satisfy the
following specifications.
Operating coil
Rated voltage: 24 VDC (Built-in
diode)
Power consumption: 0.9 W or less
(*1) Be sure to use the ones with
the voltages rated above.
Exceeding the rated voltage
may affect the ON/OFF of
other outputs.
(*2) When using a separate
power supply for this device,
connect GND of the power
supply to V- of CN16 of the
terminal block of this device.
(*3) Use a relay with a
withstanding voltage of at
least 2000 VAC between the
coil and contact.
Otherwise, there is the
likelihood of an electric shock
or fire.
• Strip 12±1 mm (15/32 ±1/32 in) of the
wire coating and insert firmly into the
terminal.
• Make sure that the copper wiring is
not short-circuiting the plates (cover,
lower case) or neighboring wires.
• Perform wiring so that the terminal
block is not strained.
If strained, use a wire guide or
junction terminal to alleviate the
stress on the terminal block.
• Do not connect the wires directly from
the top of the control panel to the
terminal block.
Moisture may enter this device along
the wiring and cause electric shock or
fire.
Advertisement
Table of Contents
