Overcast Stitch; Arrowtack - ELNA 7300 Instruction Manual

Overcast Stitch

A reinforced straight stitch and zigzag are sewn
simultaneously. If your seam does not need to be
opened flat, this stitch will sew the seam and
overcast the edge in one operation.
Select 070.
Attach overlock foot C.
NOTE: Do not set the stitch width lower than 5.0 when
using overlock foot C because the needle could hit
wires on the foot.
Place the fabric edge against the black guide on the
foot. Sew seam.

Arrowtack

This stitch is used to reinforce the corners of
pockets and pleats.
Select 077.
Attach satin stitch foot F.
Place fabric under foot so center pleat line is
horizontal in front of you. Lower presser foot so the
center bar lines up with the pleat line. (This allows
the widest part of the stitch to be sewn in the pleat
center.)
Press "Memory Auto-Lock" key, "Memory Thread
Cut" key and begin sewing. Machine will complete
arrowtack, sew locking stitch, cut threads and
automatically stop.
NOTE: Adjust foot pressure and fine adjustment
screw (see page 40) for best results on very heavy
fabrics.
110