Deutschmann Automation GmbH & Co. KG
7
Script and configuration
7.1
Overview
In the configuration mode the scripts and configurations, stored in the UNIGATE® IC, can be
replaced or updated via the serial interface.
7.2
The configuration mode
If the pin „ConfigMode" pulled to GND during the PowerUp or Reset, then the UNIGATE® IC
starts in the configuration mode. In this mode it is possible to communicate with the IC without
processing the regular software. In this mode it is possible to change the UNIGATE® IC's set-
tings of the standard software or to write a new script in the UNIGATE® IC. It shows its start in
the configuration mode by issuing a status message, which might look as follows:
"IC-DN-SC V4.03[26] (c)dA Script(8k)="Leer" Author="Deutschmann Automation GmbH" Ver-
sion="1.0" Date=21.08.2001 SN=47110001".
7.3
Update the script
The preferred version is the one, where the IC is inserted into the basis board, available from
Deutschmann Automation and the Deutschmann tools (such as the software WINGATE with
"Write Script" unser "File") are used.
On request the procedures, how to overwrite the included script can be disclosed by
Deutschmann Automation in order to automatically replace the script in an application.
7.4
Configuration of the UNIGATE® IC
UNIGATE® IC is delivered with an empty script.
The configuration of the UNIGATE® IC - DeviceNet is restricted to the setting of the fieldbus
address.
7.4.1
DeviceNet
•
Vendor-ID:
Device-type:
•
•
MAC-ID:
Poll-data length:
•
•
Product code:
7.4.2
RS232/RS485/RS422
•
RS-type:
Start bit:
•
•
Data bits:
•
Stop bit:
Parity:
•
•
Baud rate:
Default setting
7.10.10
272
12 (communication adapter)
in accordance script setting or configuration data
In accordance with script
In accordance with script
RS232
1
8
1
None
9600 Baud
This configuration can be changed via the Script.
Instruction manual UNIGATE
Script and configuration
®
IC - DeviceNet V. 2.7
23
Need help?
Do you have a question about the UNIGATE IC DeviceNet and is the answer not in the manual?