Advertisement
Step 11 - Caster Installation (optional)
If you purchased Casters for your desk, we
recommend installing them now.
A. Remove the pre-installed leveling glides from
the Feet by rotating them counterclockwise to
unthread them from the mounting holes.
B. Thread the stem of a Caster into each of the
leveling glide holes by turning it clockwise. If the
Casters have a hex nut for tightening, use a flat
wrench to tighten them.
C. If your Casters have locks, engage them. This will
keep them from rotating when it is time to flip
the desk upright.
Step 12 - Desk Placement
A. With one person located at each end of
the desk, support the desk frame and the
desktop equally and begin to tilt it slowly
toward the back of the desk so that the
Control Paddle is facing up and the backs
of the Feet are touching the floor.
B. Readjust your grip and continue to rotate
the desk until it is right side up with both
Feet completely on the floor.
C. Position your desk where you would like it to be.
1.
With Casters:
Moving is easy! If your Casters
include locks, make sure they are unlocked and
roll the desk to the desired location. Relock the
Casters to keep the desk stationary.
2.
Without Casters:
Using two people, lift your
desk (do not drag it) by holding onto the desktop
and Side Brackets together. Never lift the desk by
just the desktop, doing so will put undue stress
on the attachment screws. Be sure to hold the
frame Side Brackets when lifting. Adjust the
Leveling Glides as needed to level the desk.
D. Check your desk's surroundings to make sure
there are no obstacles in the desk's path while
being raised or lowered. Do not place any objects
underneath the desk taller than the underside of
the desk when it is in the lowered position.
© UPLIFT Desk • 800-349-3839 • info@upliftdesk.com •
upliftdesk.com
11
Advertisement
